My maytag electric dryer wont start. please help? - installing electric start on arctic cat
I bought a Maytag dryer craigs list. went well for about a week. I shot and also that the fan wheel and broke the previous owners tried to paste it back together) (idiots. I installed the fan, and it has worked well, not even 1 load of clothes, turn right on this page. I checked the switch and not travel. I have power of decision, but nothing in the works for dry hair, even the inner light. what could cause this How can these components?
Saturday, January 30, 2010
Installing Electric Start On Arctic Cat My Maytag Electric Dryer Wont Start. Please Help?
7 comments:
Theres a fuse in the first unit, so you might have a short in the plug or on the wall or the upper switching point, was trying to 3 before the call for the service.
The first thing I would do is reset switch off and on again. Then check with a multimeter the voltages (with food) to the power at the plug test. You need to 115/120 volts between the three legs or more stores, online (1) have a common line (2) a common line between (1) online (2). . Some dryer fuse in an input-lines that should be checked with a multimeter in the Ohms, the power of continuity. Then check the door of the dryer switch for proper operation.
I found the appliantologist "in the amount of charts page useful as reference books are published cabling results.
Can not accurate, but it could be worse ...
In me, I found several switches inner journey - probably triggered by the thermal regime. It was not my problem, but maybe yours.
The only light is triggered when the door is broken 1 switch or 2 or 3 does not burn to reach - such as when an internal cable broken off /. Most problems are accessible via the control panel and remove the screw to measure and know where to end the tension.
When replacing the fan, you can switch accidentally loose cable in the door, and now it has fallen. Either that, or maybe the door switch has failed completely. Since I was replaced on the front wheel, must be something simple. (A model number would be useful.)
I hope that in the case
I think it was a fan wheel 303,836. As he fled,) to the exposure of the wheel, not in a position to pull a thread out of a plastic disc (thermal fuse? Since most respondents said it was strange that began when he replaced the wheel. The craziest is being done to improvise together really, really ?????
You need a voltmeter, and power to check the timer, and if the performance is very good at, then check the performance of the device.
There should be a diagram lead somewhere on the device to the proper terminals.
Make sure the power is in the first plug.
Two things
# 1 Don t buy things to someone who does not, I know
# 2 you said ran, then you can change or set the fan? and it worked? even for a fee of 1?
If you just closed and the power of the plug, how can you say that? The switch can travel and still looks as it does not promote, t,, press again
Use a voltmeter to check everything
Post a Comment